My Cart

0 item(s)-$0.00
You have no items in your shopping cart.


providing quality supplies since 1982

call us toll free 800-722-7805


Profile Informations

Login Datas

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!

More Views

Tech Sealer


Quick Overview

• High performing, solvent based sealer
• Repels oil and water with very low odor
• Maximum stain protection


View MSDS File

A solvent-based stone sealer formulated to provide maximum protection and excellent oil and water repellency with very low odor. Modern Stone’s Tech Seal is a premium low odor, natural-look, solvent based stone sealer formulated to provide maximum stain protection and excellent oil and water repellency to a variety of substrates with little or no change in appearance. It allows for moisture vapor transmission and may also be used as a pre-grouting sealer. Greatly reduces cleaning maintenance. Use Modern Stone's Tech Seal on marble, granite, limestone, travertine, concrete/masonry, saltillo tile, clay tile, stucco, terrazzo, and grout. Test in an inconspicuous area and allow 24 hours to cure to determine ease of application and desired results. COVERAGE: Approximately 200 to 1,500 sq. ft. per gallon. APPLICATION: 1. Ensure surface is clean, dry and free of waxes or coatings. 2. Apply Clear Guard liberally using a paint pad, roller, brush, lambs wool applicator or low-pressure chemical sprayer. Distribute product evenly over entire surface to ensure uniform coverage and maximum penetration. *Note: Do not allow excess sealer to dry on surface. For denser substrates, a lighter application may be recommended in order to avoid excess product left on surface. 3. Allow sealer to dwell for up to 20 minutes, or until it begins to dry on surface. Remove excess with cotton bonnet pad or clean towels, until surface is completely dry. 4. Apply a second coat if necessary 30 minutes after initial application. 5. Bu surface for even luster. 6. Ready for foot trac in 2 hours. Fully cures in 24-48 hours. 7. Clean tools with mineral spirits.

Additional Information

SKU 8857
© PCCS. All Rights Reserved.